Posted on

GLUE IT TOGETHER

Mark Each Connection
 
Make the whole stand straight and how you would like it to sit. Take a pen and mark each
connection of a elbow or T connector to a pipe piece. This will insure the straightness of
the finished product.

 
Apply Adhesive
 
Pull each connection of either the elbow or T joint and a pipe section apart one by one
and follow the next steps:

1. Apply epoxy or PVC cement around inner lip of joint.

2. Insert pipe section.

3. Turn pipe section until pen marks line up.

4. Wait till connection dries and do the adhesive steps to the next  connection until you are finished with entire stand. (This is why I recommend fast drying epoxy rather than PVC cement.)

Advertisements